Digital PDFs

EK-DALVR-IS-B01

2000

2 pages

Original

61.0kB

Document:	Digital Alpha VME 2100 Vertical Rackmount Bezel Installation Information
Order Number:	EK-DALVR-IS
Revision:	B01
Pages:	2
Original Filename:

OCR Text

EK-DALVR-IS. B01

Digital Alpha VME 2100 Vertical Rackmount Front Bezel
Installation Information
Introduction
The front bezel kit for the Digital Alpha VME 2100 vertical rackmount chassis contains the front
bezel, four latch brackets, and eight 4-40 flathead screws. The four latch brackets must be installed
on the chassis before the chassis is installed in the RETMA or IEC cabinet.

Installing the Front Bezel
Use Figure 1 and Figure 2 along with the following procedure to install the front bezel on the
Digital Alpha VME 2100 vertical rackmount chassis:

Refer to Figure 1 and insert a latch bracket
through each of the four vertical slots
in
the chassis frame. Ensure that the latch mechanism is toward the outside edge of the chassis
frame when the bracket is inserted through the slot.

Refer to Figure 1 and secure each latch bracket to the side of the chassis with two 4-40 flathead
screws .

Set the front bezel aside until the chassis has been installed in the RETMA or IEC cabinet.

Refer to the Digital Alpha VME 2100 Owner’s Guide and perform the vertical rackmount
Digital Alpha VME 2100 installation procedure.

NOTE
If an optional removable media storage device is installed in the Digital Alpha
VME 2100 chassis, remove the corresponding blank insert on the front bezel
before installing the front bezel on the chassis.

After installing the vertical rackmount chassis in the cabinet, refer to Figure 2 and grasp the
front bezel
by the flip-down pull tabs
or by the sides.

Refer to Figure 2 and align the four strikes
chassis.

Press the front bezel onto the chassis until the four strikes snap into the four latches.

& on the front bezel with the four latches ' on the

© Digital Equipment Corporation 1995. All Rights Reserved.
Digital Equipment Corporation makes no representations that the use of its products in the manner
described in this publication will not infringe on existing or future patent rights, nor do the descriptions contained in this publication imply the granting of licenses to make, use, or sell equipment or
software in accordance with the description.
S2856

Figure 1: Installing the Latch Brackets

2
2

3
1

MLO-011605

Figure 2: Installing the Front Bezel

4
MLO-011611a