Digital PDFs

EK-DALDR-IS-B01

2000

2 pages

Original

42.9kB

Document:	Digital Alpha VME 2100 Drawer Rackmount Front Bezel Installation Information
Order Number:	EK-DALDR-IS
Revision:	B01
Pages:	2
Original Filename:

OCR Text

EK-DALDR-IS. B01

Digital Alpha VME 2100 Drawer Rackmount Front Bezel
Installation Information
Introduction
The front bezel is installed on the Digital Alpha VME 2100 drawer rackmount chassis after the
chassis has been installed in a RETMA or IEC cabinet.
Refer to the Digital Alpha VME 2100 Owner’s Guide and perform the Digital Alpha VME 2100
installation procedure for a RETMA or IEC cabinet.
NOTE
If an optional removable media storage device is installed in the Digital Alpha
VME 2100 chassis, remove the corresponding blank insert on the front bezel
before installing the front bezel on the chassis.

Installing the Front Bezel
Use Figure 1 and the following procedure to install the front bezel on the Digital Alpha VME 2100
drawer rackmount chassis:

" by the flip-down pull tabs $ or by the sides.
Align the four strikes ! on the front bezel with the four latches # on the chassis.

Press the front bezel onto the chassis until the four strikes snap into the four latches.

Grasp the front bezel

© Digital Equipment Corporation 1995. All Rights Reserved.
Digital Equipment Corporation makes no representations that the use of its products in the manner
described in this publication will not infringe on existing or future patent rights, nor do the descriptions contained in this publication imply the granting of licenses to make, use, or sell equipment or
software in accordance with the description.
S2855

Figure 1: Installing the Front Bezel

4
3
1

MLO-011599